Page 115 - tymp

Maintenance and service

<checking> Negative (-)
① Checking battery charging level terminal (black)
Charge indicator  If the battery is not used for over
two weeks, it may become hard to
start the engine. Charge the bat-
tery in this case. Positive (+)
terminal (red)
② If the battery terminal is corroded,
it cannot deliver current. If it is 4 35
T53O51A corroded or contaminated, wipe it T54O531A
with sandpaper or a brush.
The battery has the charge indicator: <charging>
① Turn the ignition switch to the
battery specification "OFF" position and remove the
check battery status battery from the tractor.
1V 80AH (0HR)
green Fully charged ② Charge the battery in a well-
ventilated area.
red Charging required ③ Charge the battery with the nor-
mal procedures and avoid quick
White Insufficient electrolyte charging.
④ Turn the charger switch OFF and
connect the cables to the nega-
tive and positive battery termi-
nals correctly.
⑤ When using a charger, its charg-
ing current should be below 10 A.

5 - 17