Page 108 - tymp
P. 108
Maintenance and service
5. replacing filter and cartridge
(3) Oil specification ④ Add hydraulic oil to the specified
Gear oil SAE 90W level.
(API GL-4 grade or higher) ⑤ Check the oil level with the dip-
stick again. If still insufficient,
cautiOn add more.
• If oil gets on your skin, it can ir- HST filter
ritate the skin and cause a skin
condition. Make sure to clean
your skin with soap and water T39O510A
or hand cleaner thoroughly.
• Make sure to cool down the ► replacing transMis-
engine sufficiently before drain- siOn fluid filter car-
ing oil. Oil is very hot and can tridge
cause a burn if changing oil ① The HST oil filter is located under
the floor.
right after the engine is stopped.
② Remove the hydraulic oil filter el-
ement by turning it counterclock-
wise with a wrench.
③ Apply a thin film of oil to the
O-ring of a new cartridge and
install the new cartridge by
tightening it with a hand. When
its packing touches the sealing
surface, turn it approx. 2/3 turns
further with a wrench.
5 - 10
